Step by Step installation of a recessed projector screen

STEP 1: Find Joists, Pipes & Cables

Find the approximate position for your projector screen and then locate and mark the position of any joists, wiring and plumbing. To aid installation, a wood/metal sensor is recommended. Available from most DIY stores 

STEP 2: Mark Out Position

Now you have the joists marked, measure the exact position for the projector screen and mark out using the stencil supplied. Simply draw around the inside of the stencil and mark all hole positions.

STEP 3: Drill Holes

Drill 8mm diameter holes through the ceiling for mounting screws. Be sure to drill the holes carefully as these will have to line up with the projector screen.

STEP 4: Cut Slot

Cut out ceiling slot along the template line, taking care to keep as close to the line as possible. Clean out the majority of plaster dust leaving a clean area for the screen.

STEP 5: Install Template

Place the template into the ceiling cavity and align it with slots and holes. Once you are happy the holes are correct, lift the mounting frame and remove the sticky pad covers then press down into position.

STEP 6: Install Transformer

Place the main transformer into the ceiling cavity and connect to the nearest suitable main power supply using supplied IEC lead. Allow the 24v plug to hang down for easy connection to the screen.

STEP 7: Install Screen

Lift the screen to the ceiling and connect the 24v plug from the transformer to the end of the screen. Note. The LEDs on the screen should light RED, then Green and Yellow. Now push the screen up into the ceiling cavity and insert all screws finger tight.

**USE SCREWS PROVIDED - DO NOT USE SCREWS LONGER THAN 30mm.

STEP 8:  Secure and Test

Finally, tighten all screws with a screwdriver. (Fit screw covers once you have tested your installation.) Your screen is now ready to use. Please read the following pages for operating instructions and programming options.